Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (Click here).



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE NO. 3 STEERING WHEEL LOWER COVER


    B238307
  1. Detach the 2 claws and remove the cover.



4. REMOVE NO. 2 STEERING WHEEL LOWER COVER


    B238308E01
  1. Detach the 2 claws and remove the cover.
    Text in Illustration 
    *A
    w/o Cruise Control System
    *B
    w/ Cruise Control System



5. REMOVE STEERING PAD


    B240146E01
  1. Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
    Text in Illustration 
    *1
    Screw Case



    B238310
  1. Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



6. REMOVE STEERING PAD SWITCH ASSEMBLY


    C292239
  1. Disconnect the connector.

  1. Remove the 4 screws.

  1. Detach the 2 claws and 4 guides to remove the steering pad switch assembly.



7. REMOVE CRUISE CONTROL MAIN SWITCH


    B239745
  1. Disconnect the connector.



    B237284
  1. Remove the 2 screws and switch.



8. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel set nut.



    C292240E01
  1. Put matchmarks on the steering wheel and main shaft.
    Text in Illustration 
    *a
    Matchmark
    *b
    Hold
    *c
    Turn

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05011)