STEERING COLUMN ASSEMBLY > REASSEMBLY |
| 1. INSTALL KEY INTERLOCK SOLENOID WIRE (w/o Smart Key System) |
Install the key interlock solenoid wire on to the install the ignition switch.
| 2. INSTALL IGNITION SWITCH ASSEMBLY (w/o Smart Key System) |
![]() |
Install the ignition switch onto the steering column upper bracket with the 2 screws.
| 3. INSTALL KEY INTERLOCK SOLENOID (w/o Smart Key System) |
![]() |
Install the key interlock solenoid onto the steering column upper bracket with the 2 screws.
Connect the connector.
| 4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System) |
![]() |
Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.
| 5. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System) |
Turn the ignition switch to ON (ACC).
![]() |
Install the ignition switch lock cylinder into the steering column upper bracket.
Make sure that the ignition switch lock cylinder is securely fixed onto the ignition switch lock cylinder.
| 6. INSPECT STEERING LOCK OPERATION (w/o Smart Key System) |
![]() |
Remove the key and check that the steering lock function is activated.
![]() |
Insert the key, turn the ignition switch ON (ACC) and check that the steering lock function is deactivated.
| 7. INSTALL STEERING LOCK ACTUATOR ASSEMBLY |
Temporarily install the steering lock actuator assembly with a new tapered-head bolt.
![]() |
Tighten the tapered-head bolt until the bolt head breaks off.
| *A | w/o Smart Key System |
| *B | w/ Smart Key System |