Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR

STEERING GEAR > REMOVAL

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE FRONT WHEELS


3. REMOVE ENGINE ASSEMBLY
  1. Remove the engine assembly (Click here).



4. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT
  1. Disconnect the No. 2 steering intermediate shaft (Click here).



5. DISCONNECT TIE ROD END SUB-ASSEMBLY LH


    C215754E01
  1. Using SST, disconnect the tie rod end assembly.

    SST
    09610-20012  



6. DISCONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



7. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


    C215750
  1. Remove the clamp and disconnect the pressure feed tube (return tube side) from the steering gear.



    C215751
  1. Using a union nut wrench, disconnect the pressure feed tube (pressure feed tube side) from the steering gear.



    C247962
  1. Remove the bolt and disconnect the pressure feed tube clamp.



8. REMOVE RACK AND PINION POWER STEERING GEAR ASSEMBLY


    C216947
  1. Remove the 2 bolts, 2 nuts and steering gear assembly.

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut fixed in place.