RADIO ANTENNA CORD > INSTALLATION |
| 1. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY |
Attach the 7 clamps to install the antenna cord.
Connect the connector.
| 2. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof) |
Apply new double-sided tape as shown in the illustration.

![]() | Marking Tape | ![]() | Double-sided Tape |
Align the marking tape wound around the antenna cord with the protrusion on the roof headlining in the illustration labeled A and attach the antenna cord to the double-sided tape.
Align the marking tape wound around the antenna cord with the V markings on the roof headlining at the 6 locations shown and attach the antenna cord to the double-sided tape.
Attach the clamp shown in the illustration labeled B.
| 3. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof) |
Apply new double-sided tape as shown in the illustration.

![]() | Marking Tape | ![]() | Double-sided Tape |
Align the marking tape wound around the antenna cord with the protrusion on the roof headlining in the illustration labeled A and attach the antenna cord to the double-sided tape.
Align the marking tape wound around the antenna cord with the V markings on the roof headlining at the 6 locations shown and attach the antenna cord to the double-sided tape.
Attach the clamp shown in the illustration labeled B.
| 4. INSTALL ROOF HEADLINING ASSEMBLY |
Install the roof headlining (Click here).
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. CHECK SRS WARNING LIGHT |
Check the SRS warning light .