Home › Vehicle Interior › METER / GAUGE / DISPLAY › ACCESSORY METER

ACCESSORY METER > INSTALLATION

for Preparation Click here



1. INSTALL ACCESSORY METER ASSEMBLY
  1. Connect the connector.

  1. Install the accessory meter assembly with the 2 screws.



2. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type)


    B296608
  1. Remove the 4 bolts.



    B352862
  1. Pull the navigation receiver assembly with brackets as shown in the illustration to detach the 6 claws on the backside of the navigation receiver assembly with brackets.

  1. Disconnect each connector to remove the navigation receiver assembly with brackets.



3. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS (for Radio and Display Type)
  1. Connect each connector.



    B352863
  1. Insert the radio and display receiver assembly with brackets to attach the 6 claws on its backside.

    NOTICE:
    When inserting the radio and display receiver assembly with brackets, do not press its knobs on it.

  1. Install the radio and display receiver assembly with brackets with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



4. INSTALL HEATER CONTROL ASSEMBLY


    E202383
  1. Attach the 4 clips to install the heater control assembly.



5. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.



6. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).