Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure (Unloaded Vehicle):

    Tire Size
    Vehicle Model
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P265/70R17 113S
    GRN280L-GKAGKA
    GRN285L-GKAGKA
    220 (2.2, 32)
    220 (2.2, 32)
    P245/60R20 107H
    GRN280L-GKAGKA
    GRN285L-GKAGKA
    220 (2.2, 32)
    220 (2.2, 32)



    C137874
  1. Using a dial indicator, check the tire runout.

    Standard tire runout:
    3.0 mm (0.118 in.) or less



2. ROTATE TIRES


C219534

HINT:
Rotate the tires as shown in the illustration.

Text in Illustration 
V100135
Front


3. INSPECT WHEEL BALANCE


    C217325E01
  1. Check and adjust the off-the-car balance.
    Text in Illustration 
    *a
    P245/60R20 107H
    *b
    P265/70R17 113S

  1. If necessary, check and adjust the on-the-car balance.

    Standard Imbalance after Adjustment:

    Tire Size
    Wheel Size
    Imbalance
    P265/70R17
    17 x 7J, 17 x 7.5J
    (Aluminum Wheel)
    6.0 g (0.0132 lb) or less
    17 x 7J, 17 x 7.5J
    (Steel Wheel)
    12 g (0.0265 lb) or less
    P245/60R20
    20 x 7J
    (Aluminum Wheel)
    6.0 g (0.0132 lb) or less

    NOTICE:
    1. The imbalance after adjustment value is the conversion value at the rim flange position.
    2. Using a cleaning detergent, remove dirt, oil and water from the surface where the balance weight is to be adhered.
    3. Do not touch the adhesive surface of the tape.
    4. Attach a sticking type balance weight to the flat surface (A) shown in the illustration.

      Width (A):
      25 mm (0.984 in.)

    5. Push the balance weight with your finger so that it securely adheres to the position.
    6. Do not reuse the balance weight.



4. INSPECT FRONT AXLE HUB
  1. for 2WD:
    Inspect the front axle hub (Click here).

  1. for 4WD:
    Inspect the front axle hub (Click here).



5. INSPECT REAR AXLE SHAFT
  1. Inspect the rear axle shaft (Click here).