Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH

PARKING BRAKE SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Remove the lower No. 1 instrument panel airbag assembly (Click here).



3. REMOVE TURN SIGNAL FLASHER ASSEMBLY


    E199221
  1. Disconnect the connector.

  1. Remove the nut and flasher.



4. REMOVE TIRE PRESSURE WARNING ECU


    C216509
  1. Disconnect the connector.

  1. Remove the bolt and tire pressure warning ECU.



5. DISCONNECT PARKING BRAKE CONTROL PEDAL ASSEMBLY
  1. Partially remove the front floor carpet.



    C215933
  1. Remove the 2 nuts and disconnect the No. 1 parking brake cable assembly from the body.

  1. Disconnect the parking brake switch connector.



    D028115
  1. Remove the 3 nuts and disconnect the parking brake control pedal assembly from the body.



6. REMOVE PARKING BRAKE SWITCH ASSEMBLY


    C215300
  1. Remove the screw and parking brake switch assembly from the parking brake control pedal assembly.