Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU

POWER STEERING ECU > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL POWER STEERING ECU ASSEMBLY
  1. Attach the 2 claws to install the power steering ECU assembly.



2. INSTALL ECU INTEGRATION BOX RH
  1. Install the ECU integration box RH with the 2 nuts and bolt.

  1. Attach the clamp and connect the connectors.

    NOTICE:
    1. Do not twist the connectors of ECU when connecting them.
    2. Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.



3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
  1. Attach the 3 claws to install the air duct.

  1. Install the screw.



4. INSTALL INSTRUMENT LOWER PANEL SUB-ASSEMBLY
  1. Connect each connector.

  1. Attach the 10 clips and guide to install the lower instrument panel sub-assembly.

  1. Install the 3 screws <B> and 2 bolts <C>.



5. INSTALL INSTRUMENT PANEL BOX DOOR COVER
  1. Attach the 2 claws and 2 guides to install the instrument panel box door cover.

    HINT:
    Use the same procedure for all the instrument panel box door covers.



6. INSTALL INSTRUMENT NO. 2 LOWER PANEL AIRBAG ASSEMBLY


    B240163
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 8 claws to install the instrument panel airbag.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



7. INSTALL INSTRUMENT LOWER COVER LH
  1. Attach the 4 claws to install the lower instrument cover LH.



8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.



9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.



10. INSTALL COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side.



11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



13. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).