DTC C1439 Steering Angle Sensor Initialization Incomplete |
DTC C1445 Vehicle Driven with Steering Angle Sensor not Initialized |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1439 | After the steering angle sensor zero point calibration is cleared due to, for example, fluctuations in the power source, the steering angle zero point calibration cannot be obtained for 60 seconds of continuous driving. |
|
| C1445 | Steering angle sensor zero point calibration cannot be obtained when the vehicle is driven without a record of steering angle sensor zero point calibration at a speed of 36 km/h (22 mph) or more for 30 seconds or more without the brake pedal being depressed. |
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTC is output.
Drive the vehicle at a speed of 40 km/h (25 mph) and turn the steering wheel to the right and left, and then check that no speed sensor and yaw rate and acceleration sensor DTCs are output (Click here).
| Result | Proceed to | |
| DTC is output | C1439 and/or C1445 | A |
| Relating to CAN communication system | B | |
| Relating to speed sensor or yaw rate and acceleration sensor | C | |
| DTC is not output | D | |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds.
Check that the centered position of the steering wheel is correctly set while driving straight ahead.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more and turn the steering wheel to the right and left.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs C1439 and C1445 are not output | A |
| Yaw rate and acceleration sensor and/or steering angle sensor DTC is output | B |
|
| ||||
| A | ||
| ||