Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1442    Invalid Data Received from Acceleration Sensor

DTC    C1443    Invalid Data Received from Yaw Rate Sensor

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
C1442
An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.
Yaw rate and acceleration sensor
C1443
An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more.

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor, perform calibration (Click here).

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine and idle it for 60 seconds, and then stop the engine.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTCs C1442 and/or C1443 are output
    A
    DTCs C1442 and C1443 are not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE YAW RATE AND ACCELERATION SENSOR (Click here)