Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning buzzer sounds to alert the driver. The sounding pattern changes depending on the distance to an obstacle.

WIRING DIAGRAM


E282883E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - NO. 1 CLEARANCE WARNING BUZZER)
  1. Disconnect the F95 clearance warning ECU assembly connector.

  1. Disconnect the F97 No. 1 clearance warning buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F95-19 (CBZ) - F97-1 (Z+)
    Always
    Below 1 Ω
    F95-20 (FF) - F97-2 (Z-)
    Always
    Below 1 Ω
    F95-19 (CBZ) - Body ground
    Always
    10 kΩ or higher
    F95-20 (FF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK NO. 1 CLEARANCE WARNING BUZZER
  1. Temporarily replace the No. 1 clearance warning buzzer with a new or normally functioning one (Click here).

  1. Check that the clearance warning buzzer sounds properly when the intuitive parking assist system detects an obstacle.

    OK:
    Buzzer sounds properly.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (NO. 1 CLEARANCE SONAR BUZZER IS DEFECTIVE)