CAN COMMUNICATION SYSTEM > Certification ECU Communication Stop Mode |
| Detection Item | Symptoms | Trouble Area |
| Certification ECU Communication Stop Mode | Either condition is met:
|
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire or branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (CERTIFICATION ECU BRANCH WIRE) |
![]() |
Disconnect the F79 certification ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F79-9 (CANH) - F79-10 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Certification ECU) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F79-15 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F79-1 (+B) - Body ground | Always | 11 to 14 V |
| F79-16 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| F79-17 (CUTB) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector (to Certification ECU) |
|
| ||||
| OK | ||
| ||