Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Start Function)

DTC    U0100    Lost Communication with ECM / PCM

DTC    U0129    Lost Communication with Brake System Control Module

DTC    U0142    Lost Communication with Main Body ECU

DTC    U0155    Lost Communication with Combination Meter

for Preparation Click here


DESCRIPTION

The power management control ECU receives information from 2 sources. It receives information via a direct line and via the CAN communication line. If the information from these 2 sources is inconsistent, this DTC is stored.

HINT:
When the power management control ECU is replaced with a new one and the cable is connected to the negative (-) battery terminal, the power source mode is reset to on (IG). When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.


DTC Code
DTC Detection Condition
Trouble Area
U0100
There is no communication from the ECM.
  1. CAN communication system
  2. ECM
U0142
There is no communication from the main body ECU.
  1. CAN communication system
  2. Main body ECU (Driver side junction block assembly)
U0129
There is no communication from the skid control ECU.
  1. CAN communication system
  2. Skid control ECU
U0155
There is no communication from the combination meter.
  1. CAN communication system
  2. Combination meter assembly

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Check for DTCs and note any codes that are output (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)