Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD ECU

AUTOMATIC RUNNING BOARD ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (Click here).

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH


    B240006E01
  1. Put protective tape around the door scuff plate assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides to remove the door scuff plate assembly LH.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE COWL SIDE TRIM BOARD LH


    B238734
  1. Remove the clip.

  1. Detach the clip and claw to remove the cowl side trim board LH.



4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Put protective tape around the No. 1 instrument cluster finish panel garnish.



  1. Grip the No. 1 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 1 instrument cluster finish panel garnish.


    B353454E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B239280E01
  1. Using a screwdriver, detach the 2 claws to open the cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



    B239277
  1. Remove the 2 bolts <C>.

  1. Detach the 13 clips and 2 guides.

  1. Disconnect each connector and hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240153
  1. Remove the 4 bolts and airbag assembly.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



7. REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY


    E197200
  1. Disconnect the 3 connectors.



    E197201E06
  1. Disconnect the 2 connectors labeled (1) as shown in the illustration.

  1. Disconnect the connector labeled (2).



    E197202
  1. Remove the bolt and 2 nuts and disconnect the driver side junction block assembly.



    E178377
  1. Detach the claw and disconnect the connector as shown in the illustration.



    E178379
  1. Detach the 2 claws and release the connector's lock as shown in the illustration.



    E178381
  1. Detach the claw and disconnect the connector as shown in the illustration.

  1. Remove the driver side junction block assembly.



8. REMOVE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY


    B295788
  1. Disconnect the 2 connectors.

  1. Remove the 2 bolts.

  1. Disengage the guide and remove the side auto step controller ECU assembly.