Home › Power Source / Network › POWER DISTRIBUTION › POWER MANAGEMENT CONTROL ECU

POWER MANAGEMENT CONTROL ECU > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL POWER MANAGEMENT CONTROL ECU
  1. Attach the 2 claws to install the power management control ECU.



2. INSTALL ECU INTEGRATION BOX RH
  1. Install the ECU integration box RH with the 2 nuts and bolt.

  1. Attach the clamp.

  1. Connect all the connectors.

    NOTICE:
    1. Do not twist the connectors of the ECU when connecting them.
    2. Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.



3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
  1. Attach the 3 claws to install the air duct.

  1. Install the screw.



4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector.

  1. Attach the 10 clips and guide to install the lower instrument panel sub-assembly.

  1. Install the 3 screws <B> and 2 bolts <C>.



5. INSTALL INSTRUMENT PANEL BOX DOOR COVER
  1. Attach the 2 claws and 2 guides to install the instrument panel box door cover.

    HINT:
    Use the same procedure for all the instrument panel box door covers.



6. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240163
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 8 claws to install the instrument panel airbag.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



7. INSTALL LOWER INSTRUMENT COVER LH
  1. Attach the 4 claws to install the lower instrument cover LH.



8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.



9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

HINT:
Use the same procedure described for the No. 1 instrument cluster finish panel garnish.

  1. Install the No. 2 instrument cluster finish panel garnish .



10. INSTALL COWL SIDE TRIM BOARD RH
  1. Attach the clip and claw to install the cowl side trim board.

  1. Install the clip.



11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



13. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).