Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER

AIR CONDITIONING AMPLIFIER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH


    B246532
  1. Put protective tape around the door scuff plate.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE COWL SIDE TRIM BOARD RH


    B246533
  1. Remove the clip.

  1. Detach the clip and claw and remove the cowl side trim board.



4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Open the instrument cluster finish panel lid.

  1. Put protective tape around the No. 2 instrument cluster finish panel garnish.



  1. Grip the No. 2 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 2 instrument cluster finish panel garnish.


    B246534E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B239284
  1. Detach the 3 clips and 2 guides to remove the No. 2 instrument panel under cover sub-assembly.



6. REMOVE LOWER INSTRUMENT COVER LH


    B239283E01
  1. Put protective tape around the lower instrument cover LH.

  1. Using a screwdriver, detach the 4 claws to remove the lower instrument cover LH.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240162
  1. Remove the 3 bolts.

  1. Detach the 8 claws and remove the instrument panel airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



8. REMOVE INSTRUMENT PANEL BOX DOOR COVER


    B239281E01
  1. Using a screwdriver, detach the 2 claws and 2 guides to remove the instrument panel box door cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for all the instrument panel box door covers.



9. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B239282
  1. Remove the 3 screws <B> and 2 bolts <C>.

  1. Detach the 10 clips and guide.

  1. Disconnect each connector and remove the lower instrument panel sub-assembly.



10. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    E197382
  1. Remove the screw.

  1. Detach the 2 claws and remove the air duct.



11. REMOVE ECU INTEGRATION BOX RH


B240503
  1. Disconnect the connectors and detach the clamp.

  1. Remove the 2 nuts, bolt and ECU integration box RH.



12. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY


B240505
  1. Detach the 2 claws and remove the air conditioning amplifier assembly.