Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE

SPIRAL CABLE > REMOVAL

for Preparation Click here




1. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel assembly (Click here).



2. REMOVE LOWER STEERING COLUMN COVER


    C216494
  1. Remove the 2 screws.

  1. Detach the 2 claws to remove the steering column lower cover.



3. REMOVE UPPER STEERING COLUMN COVER


    C216495
  1. Detach the 4 clips.

  1. Detach the claw to remove the steering column upper cover.



4. REMOVE SPIRAL CABLE SUB-ASSEMBLY


    B240150
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.

    NOTICE:
    1. Do not replace the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.
    2. Do not rotate the spiral cable when the ignition switch is ON and the battery cable is connected.
    3. Make sure the steering wheel is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).
    4. Do not remove the steering angle sensor from the spiral cable.