Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Front Passenger Side)

KNEE AIRBAG ASSEMBLY (for Front Passenger Side) > INSTALLATION

for Preparation Click here



1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240163
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 8 claws to install the instrument panel airbag.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL LOWER INSTRUMENT COVER LH
  1. Attach the 4 claws to install the lower instrument cover LH.



3. INSTALL FRONT NO. 2 CONSOLE BOX INSERT
  1. Attach the 2 clips and guide to install the front No. 2 console box insert.



4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.



5. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.



6. INSTALL COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side.



7. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



9. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).