Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Install the side airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that the side airbag sensor is not loose.

  1. Connect the connector.



2. INSTALL FRONT DOOR GLASS WEATHERSTRIP INNER LH


    B240611
  1. Attach the 4 claws to install the front door inner glass weatherstrip LH as shown in the illustration.



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B240612
  1. Connect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH.



    B240574
  1. Connect the connector.



    B354466E01
  1. Attach the front door trim board sub-assembly LH to the 4 claws of the front door inner glass weatherstrip LH as shown in the illustration.

  1. Attach the reference boss.
    Text in Illustration 
    *1
    Reference Boss



    B353478
  1. Attach the 11 clips to install the front door trim board sub-assembly LH.

  1. Install the 3 screws.



    B353477
  1. Attach the 4 claws to install the 2 door armrest caps.



4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH


    B357473
  1. Attach the 3 claws to install the No. 2 door inside handle bezel LH.



5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    B240255
  1. Attach the 2 clips to install the front door lower frame bracket garnish LH.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).