Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    B240255
  1. Detach the 2 clips to remove the front door lower frame bracket garnish LH.



3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH


    B240256E01
  1. Using a moulding remover, detach the 3 claws to remove the No. 2 door inside handle bezel LH as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover



4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B353477
  1. Detach the 4 claws to remove the 2 door armrest caps.



    B353478
  1. Remove the 3 screws.

  1. Detach the 11 clips.



    B353479E01
  1. Pull out the front door trim board sub-assembly LH in the direction indicated by the arrow shown in the illustration.

  1. Raise the front door trim board sub-assembly LH and detach the 4 claws and reference boss to remove the front door trim board sub-assembly LH together with the front door inner glass weatherstrip LH.
    Text in Illustration 
    *1
    Reference Boss



    B240574
  1. Disconnect the connector.



    B238525
  1. Disconnect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH.



5. REMOVE FRONT DOOR GLASS WEATHERSTRIP INNER LH


    B238526
  1. Using a screwdriver, detach the 4 claws to remove the front door inner glass weatherstrip LH from the front door trim board sub-assembly LH as shown in the illustration.



6. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH


    B240198
  1. Disconnect the connector.

  1. Remove the bolt and side airbag sensor.