Home › Vehicle Interior › SEAT BELT › REAR NO. 2 SEAT INNER BELT ASSEMBLY

REAR NO. 2 SEAT INNER BELT ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
  1. Remove the rear No. 2 seat assembly LH (Click here).



2. REMOVE REAR SEAT LOWER CUSHION HINGE COVER RH


    B238682E01
  1. Remove the 2 screws.
    Text in Illustration 
    *1
    Guide

  1. Detach the 2 claws and guide and remove the cover.



3. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY LH


B241710
  1. Using a T45 "TORX" socket wrench, remove the bolt and inner belt assembly.