Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR

AUTOMATIC LIGHT CONTROL SENSOR > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the instrument panel sub-assembly (Click here).



2. REMOVE NO. 1 HEATER TO REGISTER DUCT


    B239293
  1. Remove the 4 screws and No. 1 heater to register duct.



3. REMOVE NO. 2 HEATER TO REGISTER DUCT


    B239294
  1. Remove the 4 screws and No. 2 heater to register duct.



4. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B239291
  1. Remove the screw.

  1. Detach the 2 claws to remove the No. 1 side defroster nozzle duct.



5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B239292
  1. Remove the screw.

  1. Detach the 2 claws to remove the No. 2 side defroster nozzle duct.



6. REMOVE NO. 3 HEATER TO REGISTER DUCT


    B239289
  1. Remove the 2 screws.

  1. Detach the claw to remove the No. 3 heater to register duct.



7. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    B152660
  1. Disconnect the connector.

  1. Detach the 2 claws and remove the sensor.