Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

DTC    25    Short to Battery in Motor RH Circuit

DTC    26    Short to Battery in Motor LH Circuit

for Preparation Click here


DESCRIPTION

When there is a short to battery in the side auto step motor circuit, the side auto step controller ECU assembly will not operate the automatic running board.

DTC No.
Detection Condition
Trouble Area
25
Short to battery in the stowing or deploying side of the side auto step motor LH circuit when the automatic running board is not in operation.
  1. Wire harness or connector
  2. Side auto step controller ECU assembly
26
Short to battery in the stowing or deploying side of the side auto step motor RH circuit when the automatic running board is not in operation.

WIRING DIAGRAM


E237747E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU)
  1. Disconnect the O25*1 or N23*2 side auto step motor assembly connector.

    1. *1: for LH
    2. *2: for RH

  1. Disconnect the A42 side auto step controller ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for LH:
    Tester Connection
    Condition
    Specified Condition
    A42-3 (STW1) - Body ground
    When the automatic running board LH is not in operation.
    Below 1 V
    A42-4 (DPL1) - Body ground
    When the automatic running board LH is not in operation.
    Below 1 V
    for RH:
    Tester Connection
    Condition
    Specified Condition
    A42-2 (STW2) - Body ground
    When the automatic running board RH is not in operation.
    Below 1 V
    A42-1 (DPL2) - Body ground
    When the automatic running board RH is not in operation.
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY (Click here)