Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

DTC    11    Short in Motor LH

DTC    12    Short in Motor RH

for Preparation Click here


DESCRIPTION

When there is a short in the side auto step motor circuit, the side auto step controller ECU assembly halts the operation of the automatic running board.

DTC No.
Detection Condition
Trouble Area
11
More than 44 A of current is flowing through the side auto step motor LH.
  1. Wire harness or connector
  2. Side auto step motor assembly
12
More than 44 A of current is flowing through the side auto step motor RH.

WIRING DIAGRAM


E237747E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU)
  1. Disconnect the O25*1 or N23*2 side auto step motor assembly connector.

    1. *1: for LH
    2. *2: for RH

  1. Disconnect the A42 side auto step controller ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH:
    Tester Connection
    Condition
    Specified Condition
    A42-3 (STW1) - A42-4 (DPL1)
    Always
    10 kΩ or higher
    for RH:
    Tester Connection
    Condition
    Specified Condition
    A42-2 (STW2) - A42-1 (DPL2)
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SIDE AUTO STEP MOTOR ASSEMBLY (Click here)