Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD

AUTOMATIC RUNNING BOARD > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System)
(Click here)


2. REMOVE STEP PLATE


  1. Using a 5 mm hexagon wrench, remove the 4 hexagon bolts and step plate.


    B295790



3. REMOVE POWER LIFT STEP ASSEMBLY


  1. Disconnect the connector.


    B295791

  1. Remove the 4 bolts, 2 nuts and power lift step assembly.