Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

DTC    62    Motor LH Current Senser

DTC    63    Motor RH Current Senser

for Preparation Click here


DESCRIPTION

When the side auto step motor current detection sensor inside the side auto step controller ECU assembly detects a current of less than 1 A when the automatic running board is operating, the side auto step controller ECU assembly does not operate the automatic running board.

DTC No.
Detection Condition
Trouble Area
61
When the side auto step motor assembly LH is operating, there is less than 1 A of current detected in the side auto step ECU even when the hall effect pluses are input.
  1. Wire harness or connector
  2. Side auto step controller ECU assembly
62
When the side auto step motor assembly RH is operating, there is less than 1 A of current detected in the side auto step ECU even when the hall effect pluses are input.

WIRING DIAGRAM


E237747E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU)
  1. Disconnect the O25*1 or N23*2 side auto step motor assembly connector.

    1. *1: for LH
    2. *2: for RH

  1. Disconnect the A42 side auto step controller ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH:
    Tester Connection
    Condition
    Specified Condition
    O25-4 (STW1) - A42-3 (STW1)
    Always
    Below 1 Ω
    O25-5 (DPL1) - A42-4 (DPL1)
    Always
    Below 1 Ω
    for RH:
    Tester Connection
    Condition
    Specified Condition
    N23-4 (STW2) - A42-2 (STW2)
    Always
    Below 1 Ω
    N23-5 (DPL2) - A42-1 (DPL1)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.PERFORM COOL DOWN
  1. Do not operate the automatic running board in order to cool down the side auto step motor assembly.


NEXT


3.CHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY (Click here)
OK

END