Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

DTC    64    Motor LH Over Temperature

DTC    65    Motor RH Over Temperature

for Preparation Click here


DESCRIPTION

When the side auto step controller ECU assembly detects the overheating in the system, it stops the operation of the automatic running board.

DTC No.
Detection Condition
Trouble Area
64
The side auto step motor assembly LH high temperature sensor circuit in the side auto step ECU functions.
  1. Wire harness or connector
  2. Side auto step controller ECU assembly
65
The side auto step motor assembly RH high temperature sensor circuit in the side auto step ECU functions.

INSPECTION PROCEDURE

1.PERFORM COOL DOWN
  1. Do not operate the automatic running board in order to cool down the side auto step controller ECU assembly and side auto step motor assembly.


NEXT


2.CHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY (Click here)
OK

END