Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

Refer to ABS Warning Light Remains ON .

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

1.INSPECT ABS WARNING LIGHT
  1. Disconnect the A6 skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Check that the ABS warning light comes on.

    OK:
    ABS warning light comes on.



NG
Go to step 2
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)  

2.CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the A6 skid control ECU connector.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


3.READ VALUE USING TECHSTREAM (ABS WARNING LIGHT)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.


ABS/VSC/TRAC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ABS Warning Light
ABS warning light/ ON or OFF
OFF
-
  1. When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List (Click here).


ABS/VSC/TRAC 
Tester Display
Test Part
Control Range
Diagnostic Note
ABS Warning Light
ABS warning light
Warning light ON/OFF
Observe the combination meter.

Result 
Result
Proceed to
Data List Display
Data List Display when Performing Active Test ON/OFF Operation
ON
Does not change between ON and OFF
A
Changes between ON and OFF
B
OFF
Does not change between ON and OFF
A
Changes between ON and OFF
B


B
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)