Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Crawl Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

Refer to Crawl Indicator Light does not Come ON .

WIRING DIAGRAM

Refer to Crawl Indicator Light does not Come ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

1.READ VALUE USING TECHSTREAM (CRAWL CONTROL LIGHT)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.


ABS/VSC/TRAC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Crawl Control Light
Crawl control indicator light/ ON or OFF
ON: Indicator light on
OFF: Indicator light off
-
  1. When performing the Crawl Control Light Active Test, check Crawl Control Light in the Data List (Click here).


ABS/VSC/TRAC 
Tester Display
Test Part
Control Range
Diagnostic Note
Crawl Control Light
Crawl control indicator light
Indicator light ON/OFF
Observe the combination meter.

Result 
Result
Proceed to
Data List Display
Data List Display when Performing Active Test ON/OFF Operation
ON
Does not change between ON and OFF
A
Changes between ON and OFF
B
OFF
Does not change between ON and OFF
A
Changes between ON and OFF
B


B
Go to step 2
A

REPLACE MASTER CYLINDER SOLENOID (Click here)  

2.READ VALUE USING TECHSTREAM (CRAWL CONTROL MAIN SWITCH)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / D-SEAT SW / Data List.

    D-SEAT SW 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Crawl Control Main Switch
    Crawl control switch/ ON or OFF
    ON: Crawl switch on
    OFF: Crawl switch off
    -

    OK:
    The Techstream displays ON or OFF according to crawl control switch operation.



NG
REPLACE DRIVE MONITOR SWITCH (Click here)
OK

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)