Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C120A    ECU Initial Setting Incomplete

for Preparation Click here


DESCRIPTION

w/ Downhill Assist Control or w/ Crawl Control:
When the master cylinder solenoid (skid control ECU) is replaced, the master cylinder solenoid (skid control ECU) must be informed that the vehicle is equipped with downhill assist control and/or crawl control.

DTC Code
DTC Detection Condition
Trouble Area
C120A
The master cylinder solenoid is not informed that the vehicle is equipped with downhill assist control or crawl control and downhill assist control or crawl control operates.
Calibration not performed

INSPECTION PROCEDURE

1.PERFORM CALIBRATION
  1. Perform calibration (Click here).

    NOTICE:
    If a DTC is output after replacing the master cylinder solenoid, it is possible that calibration has not been performed or the zero point calibration data was not cleared when calibration was performed.


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC C120A is output
    A
    DTC C120A is not output
    B



B
END
A


3.CHECK TEST MODE DTC
  1. Switch the vehicle to test mode, perform the downhill assist control switch or crawl switch signal check, and then check that DTC C1379 is cleared (Click here).
    Result 
    Result
    Proceed to
    DTC is not cleared
    A
    DTC is cleared
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO DTC C1379 (Click here)