Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2661    Lost Communication with Combination Meter

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the drive monitor switch and combination meter assembly stops 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B2661
No communication between the drive monitor switch and combination meter assembly for 10 seconds or more.
  1. Drive monitor switch
  2. Combination meter assembly
  3. Harness or connector

WIRING DIAGRAM


C218621E02


INSPECTION PROCEDURE

NOTICE:
  1. When using the Techstream with the ignition switch off to troubleshoot:
    Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
  2. Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2661 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK HARNESS AND CONNECTOR (DRIVE MONITOR SWITCH - COMBINATION METER)
  1. Disconnect the U1 drive monitor switch connector.

  1. Disconnect the F14 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U1-4 (LIN) - F14-6 (LINT)
    Always
    Below 1 Ω
    U1-4 (LIN) or F14-6 (LINT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)


    E200096E04
  1. Disconnect the F14 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F14-20 (E1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F14-15 (B) - Body ground
    Always
    11 to 14 V
    F14-17 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Combination Meter Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMBINATION METER ASSEMBLY
  1. Temporarily replace the combination meter assembly with a new or normally functioning one (Click here).


NEXT


6.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7.CHECK FOR DTC
  1. Check for DTCs (Click here).



NG
REPLACE DRIVE MONITOR SWITCH
OK

END (COMBINATION METER IS DEFECTIVE)