Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2662    Lost Communication with Clock/Outside Temperature Display

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the drive monitor switch and accessory meter assembly stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B2662
No communication between the drive monitor switch and accessory meter assembly for 10 seconds or more.
  1. Drive monitor switch
  2. Accessory meter assembly
  3. Harness or connector

WIRING DIAGRAM


C211493E23


INSPECTION PROCEDURE

NOTICE:
  1. When using the Techstream with the ignition switch off to troubleshoot:
    Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
  2. Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2662 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK HARNESS AND CONNECTOR (DRIVE MONITOR SWITCH - ACCESSORY METER)
  1. Disconnect the U1 drive monitor switch connector.

  1. Disconnect the G3 accessory meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U1-4 (LIN) - G3-4 (DAT2)
    Always
    Below 1 Ω
    U1-4 (LIN) or G3-4 (DAT2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ACCESSORY METER - BATTERY AND BODY GROUND)


    C216968E01
  1. Disconnect the G3 accessory meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G3-1 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G3-5 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Accessory Meter Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE ACCESSORY METER ASSEMBLY
  1. Temporarily replace the accessory meter assembly with a new or normally functioning one (Click here).


NEXT


6.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2662 is not output.



NG
REPLACE DRIVE MONITOR SWITCH
OK

END (ACCESSORY METER IS DEFECTIVE)