Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM

DTC    C1882/82    Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The stabilizer control ECU recognizes the ignition switch ON signal based on the voltage input to the IG terminal.

DTC Code
DTC Detection Condition
Trouble Area
C1882/82
The IG terminal voltage is 10 V or less or 16 V or higher for 0.5 seconds.
  1. Battery
  2. Charging system
  3. KDSS fuse
  4. Harness or connector
  5. Stabilizer control ECU

WIRING DIAGRAM


C194309E04


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING TECHSTREAM (IG POWER SOURCE VOLTAGE)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / KDSS / Data List.

  1. Select the item below in the Data List, and read the value displayed on the Techstream.

    KDSS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG Power Source Voltage
    IG Power Source Voltage/
    Min.: 0.0 V
    Max.: 25.5 V
    Ignition switch ON: 11 to 14 V
    -

    Standard voltage:
    11 to 14 V



NG
Go to step 3
OK


2.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE STABILIZER CONTROL ECU (Click here)  

3.CHECK HARNESS AND CONNECTOR (IG TERMINAL)
  1. Disconnect the stabilizer control ECU connector.



    C215169E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F70-24 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Stabilizer Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (GND TERMINAL)
  1. Disconnect the stabilizer control ECU connector.



    C215169E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F70-22 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Stabilizer Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STABILIZER CONTROL ECU (Click here)