Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat)

FRONT SEAT ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
The procedure listed below is for the RH side.



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the seat wire connectors under the seat.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the seat track adjusting handle to move the front seat assembly to the rearmost position.



    B239223E01
  1. Tighten the 2 bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Operate the seat track adjusting handle to move the front seat assembly to the foremost position.



    B239222E01
  1. Tighten the 2 bolts in the order indicated in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



2. INSTALL OUTER SEAT TRACK COVER RH


    B239221
  1. Move the outer seat track cover RH in the direction of the arrow to attach the 4 guides.

  1. Attach the 2 claws to install the outer seat track cover RH.



3. INSTALL INNER SEAT TRACK BRACKET COVER RH


    B239219
  1. Move the inner seat track bracket cover RH in the direction of the arrow to attach the 2 guides.

  1. Attach the 2 claws to install the inner seat track bracket cover RH.



4. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER RH
  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B239217
  1. Move the front seat outer track bracket cover RH in the direction of the arrow to attach the 2 claws and guide.

  1. Attach the 2 claws to install the front seat outer track bracket cover RH.



5. INSTALL FRONT SEAT INNER TRACK BRACKET COVER RH


    B239215
  1. Move the front seat inner track bracket cover RH in the direction of the arrow to attach the 2 guides.

  1. Attach the 2 claws to install the front seat inner track bracket cover RH.



6. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Install the front seat headrest assembly.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



8. CHECK SRS WARNING LIGHT
(Click here)