Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU

CLEARANCE WARNING ECU > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL CLEARANCE WARNING ECU ASSEMBLY
  1. Install the clearance warning ECU with the bolt.

  1. Connect the connector.



2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240154
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the airbag assembly with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Connect each connector and hood lock control cable assembly.

  1. Attach the 13 clips and 2 guides to install the lower instrument panel finish panel sub-assembly.

  1. Install the 2 bolts <C>.

  1. Attach the 2 claws to close the cover.



4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.



5. INSTALL COWL SIDE TRIM BOARD LH
  1. Attach the clip and claw to install the cowl side trim board LH.

  1. Install the clip.



6. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly LH.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).