Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU

CLEARANCE WARNING ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH


    B240006E01
  1. Put protective tape around the door scuff plate assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides to remove the door scuff plate assembly LH.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE COWL SIDE TRIM BOARD LH


    B238734
  1. Remove the clip.

  1. Detach the clip and claw to remove the cowl side trim board LH.



4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Put protective tape around the No. 1 instrument cluster finish panel garnish.



  1. Grip the No. 1 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 1 instrument cluster finish panel garnish.


    B353454E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B239280E01
  1. Using a screwdriver, detach the 2 claws to open the cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



    B239277
  1. Remove the 2 bolts <C>.

  1. Detach the 13 clips and 2 guides.

  1. Disconnect each connector and hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240153
  1. Remove the 4 bolts and airbag assembly.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



7. REMOVE CLEARANCE WARNING ECU ASSEMBLY


E198645
  1. Disconnect the connector.

  1. Remove the bolt and clearance warning ECU.