Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)

REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE REAR SEAT ASSEMBLY LH
  1. Remove the rear seat assembly LH (Click here).



2. REMOVE REAR SEAT UPPER RECLINING COVER LH


B237615E01
  1. Using a screwdriver, detach the 3 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



3. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


B237616
  1. Remove the 3 screws and handle.



4. REMOVE CENTER SEAT HINGE COVER RH


B237617
  1. Using a clip remover, remove the clip.

  1. Detach the 2 guides and remove the cover.



5. REMOVE REAR SEAT CUSHION MOULDING LH


B237619
  1. Using a clip remover, detach the clip.

  1. Using a moulding remover, detach the 3 claws.

  1. Move the moulding in the direction of the arrow to detach the guide and remove the moulding.



6. REMOVE REAR SEATBACK LOCK STRIKER COVER LH


B237621
  1. Using a clip remover, detach the 3 clips and remove the cover.



7. REMOVE SEAT CUSHION COVER WITH PAD


    B237622
  1. Detach the hooks.



    B237624
  1. Detach the hook and remove the seat cushion cover with pad.



8. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH


B237670
  1. Remove the bolt and inner belt and disconnect the 3 point type belt.