Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)

REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE REAR SEAT ASSEMBLY RH
  1. Remove the rear seat assembly (Click here).



2. REMOVE REAR SEAT CUSHION MOULDING RH


B237716
  1. Using a clip remover, detach the clip.

  1. Using a moulding remover, detach the 3 claws.

  1. Move the moulding in the direction of the arrow to detach the guide and remove the moulding.



3. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH


B241730E01
  1. Remove the bolt and inner belt.