Home › Vehicle Interior › SEAT BELT › REAR CENTER SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)

REAR CENTER SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
  1. Install the inner belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



2. INSTALL REAR SEAT ASSEMBLY RH
  1. Install the rear seat assembly RH (Click here).