Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)

REAR NO. 1 SEAT INNER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH


B241731E01
  1. Install the inner belt with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.

    Text in Illustration 
    *a
    Protruding Part



2. INSTALL REAR SEAT CUSHION MOULDING RH


B237717
  1. Move the moulding in the direction of the arrow to attach the guide and install the moulding.

  1. Attach the 3 claws and clip.



3. INSTALL REAR SEAT ASSEMBLY RH
  1. Install the rear seat assembly RH (Click here).