KINETIC DYNAMIC SUSPENSION SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT INDICATOR LIGHT |
Check that the KDSS indicator light comes on for 2 seconds when the ignition switch is turned to ON.
If the indicator check result is not normal, proceed to troubleshooting for the Problem Symptoms Table (Click here).
| 2. INSPECT FLUID PRESSURE |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / KDSS / Data List.
Select the item below in the Data List, and read its value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Oil Pressure Sensor | Oil pressure sensor/ Min.: -784.79 MPa (-8002.66 kgf/cm2, -113794.55 psi) Max.: 784.76 MPa (8002.35 kgf/cm2, 113790.20 psi) | 2.6 MPa (26.5 kgf/cm2, 377 psi) to 3.0 MPa (30.6 kgf/cm2, 435 psi): When vehicle stopped and fluid temperature 20°C (68°F) | - |