Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD

AUTOMATIC RUNNING BOARD > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL POWER LIFT STEP ASSEMBLY
  1. Install the power lift step assembly with the 2 nuts and 4 bolts.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }

  1. Connect the connector.



2. INSTALL STEP PLATE
  1. Open the door and deploy the side auto step fully.



    B295794E01
  1. Using a 5 mm hexagon wrench, install the step plate with the 4 hexagon bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

    HINT:
    After replacing the power lift step assembly with a new one, install the step plate, and then cut off the clamp with the power lift step assembly extended.

    Text in Illustration 
    *1
    Clamp



3. INSTALL ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System)
(Click here)