Home › Vehicle Exterior › WIPER / WASHER › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE WINDSHIELD WASHER RELAY


    E201331E01
  1. Remove the windshield washer relay from the engine room relay box.
    Text in Illustration 
    *1
    Windshield Wiper Relay



3. INSPECT WINDSHIELD WASHER RELAY


    B242124E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the windshield washer relay.



4. INSTALL WINDSHIELD WASHER RELAY
  1. Install the windshield washer relay to the engine room relay box.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).