Home › Audio / Visual / Telematics › CELLULAR COMMUNICATION › SAFETY CONNECT SYSTEM

SAFETY CONNECT SYSTEM > GREEN INDICATOR REMAINS OFF

for Preparation Click here


DESCRIPTION

After the ignition switch is turned to ON, the DCM (Telematics Transceiver) will enter a self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn off followed by the manual (SOS) switch green indicator illuminating and remaining on under normal operation. If neither red nor green indicators remain on, verification of the subscription should be performed.

INSPECTION PROCEDURE

1.CONFIRM GREEN INDICATOR COMES ON
  1. After the ignition switch is turned to ON and the manual (SOS) switch red indicator has come on for 2 seconds, confirm that the manual (SOS) switch green indicator comes on for 2 seconds.

    OK:
    Green indicator comes on.



NG
Go to step 6
OK


2.CONFIRM SUBSCRIPTION MODE
  1. Confirm the indicator status 5 seconds after the ignition switch is turned to ON.
    Result 
    Result
    Proceed to
    Green indicator remains on
    A
    Green indicator remains off
    B
    Red and green indicators both flashing (1 second intervals, for 20 seconds)
    C

    HINT:
    If the red and green indicators are flashing, the system is in shipping mode, so the system should be changed to either active mode or deactive mode.



B
Go to step 3

C
CHANGE SUBSCRIPTION MODE
A

CHECK FOR INTERMITTENT PROBLEMS 

3.INPUT VIN WITH TECHSTREAM
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and wait for 10 seconds.

  1. Select "Vehicle Inquiry" and input the VIN.


NEXT


4.CONFIRM SUBSCRIPTION MODE
  1. Confirm the indicator status 5 seconds after the ignition switch is turned to ON.
    Result 
    Result
    Proceed to
    Green indicator remains on
    A
    Green indicator remains off
    B



B
Go to step 5
A

END 

5.REPLACE DCM (TELEMATICS TRANSCEIVER)
  1. Replace the DCM (Telematics Transceiver) (Click here).

    NOTICE:
    1. The ignition switch must be off.
    2. Do not replace the DCM (Telematics Transceiver) with one from another vehicle.


NEXT

PERFORM DCM ACTIVATION (Click here)  

6.CHECK FOR DTC
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and wait for 10 seconds.

  1. Perform "Health Check" and check for current DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
A


7.REPLACE DCM (TELEMATICS TRANSCEIVER)
  1. Replace the DCM (Telematics Transceiver) (Click here).

    NOTICE:
    1. The ignition switch must be off.
    2. Do not replace the DCM (Telematics Transceiver) with one from another vehicle.


NEXT

PERFORM DCM ACTIVATION (Click here)