Home › Engine / Hybrid System › FA20 COOLING › THERMOSTAT (for Engine Coolant)

THERMOSTAT (for Engine Coolant) > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST MANIFOLD
(Click here)


2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the local regulations.



    A277916
  1. Remove the service hole cover from the front bumper under cover.

  1. Connect a hose with an inside diameter of 8 mm (0.315 in.) to the drain plug.



    A277917
  1. Loosen the radiator drain cock plug.



    A279728
  1. Open the air bleed plug on the heater hose side. (for LHD)



    A279727
  1. Open the air bleed plug on the heater hose side. (for RHD)

  1. Remove the radiator cap and drain the coolant.



3. SEPARATE OUTLET RADIATOR HOSE


    A276519
  1. Loosen the hose clamp and disconnect the outlet radiator hose from the water outlet.

    HINT:
    Since the radiator hose must be attached in the correct position, apply match marks before removing it.



4. REMOVE WATER OUTLET


    A276520
  1. Remove the 2 bolts and water outlet.



5. REMOVE THERMOSTAT
  1. Remove the thermostat.

  1. Remove the thermostat gasket from the thermostat.