Home › Engine / Hybrid System › FA20 INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE AIR FUEL RATIO SENSOR
(Click here)


2. REMOVE HEATED OXYGEN SENSOR
(Click here)


3. REMOVE NO. 2 ENGINE UNDER COVER


    A278295
  1. Remove the 7 bolts and the No. 2 engine under cover.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A277952
  1. Remove the 2 nuts and disconnect the exhaust joint pipe.



    A277953
  1. Remove the 2 nuts and the 2 bolts.

  1. Remove the 2 compression springs and disconnect the center exhaust pipe assembly.



    A277954
  1. Remove the bolt and the front exhaust pipe assembly.

  1. Remove the 2 gaskets.



5. REMOVE EXHAUST MANIFOLD


    A277950
  1. Remove the 2 nuts and disconnect the front exhaust pipe sub-assembly.

  1. Remove the gasket.



    A277951
  1. Remove the 6 nuts and the exhaust manifold.

  1. Remove the 2 gaskets.