PARK / NEUTRAL POSITION SWITCH > INSTALLATION |
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Clean the bolt and the bolt hole.
![]() |
Apply adhesive to 2 or 3 threads on the end of the bolt.
| *1 | Adhesive |
Temporarily install the park/neutral position switch assembly with the bolt.
Install a new lock washer and the nut to the park/neutral position switch assembly.
Temporarily install the transmission control shaft lever RH.
![]() |
Turn the transmission control shaft lever RH counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
Remove the transmission control shaft lever RH.
![]() |
Align the neutral basic line with the groove as shown in the illustration, and tighten the bolt.
| *a | Neutral Basic Line |
| *b | Groove |
Using a screwdriver, bend the tabs of the lock washer.
Connect the park/neutral position switch connector.
| 2. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH |
Install the transmission control shaft lever RH with the spring washer and nut.
| 3. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY |
Apply MP grease to the pin.
Install the floor shift gear shifting rod sub-assembly to the transmission control shaft lever RH with the spacer, pin and clip.
| 4. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from P to R with the ignition switch to ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.
Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to M.
Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.
If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lock control unit assembly installation condition.
| 7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Apply the parking brake and turn the ignition switch to ON.
Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start when the shift lever is in other positions.
Check that the back-up light illuminates and the reverse warning buzzer sounds only when the shift lever is in R.
If a malfunction failure is found, check the park/neutral position switch assembly for continuity.