Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
The power window system utilizes a mechanism in which the door glass moves down slightly when the door is opened, and in which the glass moves up when the door closed in order to prevent the door molding from being damaged. When the negative (-) battery terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



2. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


3. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    C260576
  1. Remove the clip and pin the floor shift gear shifting rod sub-assembly from the transmission control shaft lever RH.



4. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH


    C260608
  1. Remove the nut, spring washer and the transmission control shaft lever RH.



5. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Disconnect the park/neutral position switch connector.



    C104746
  1. Using a screwdriver, bend the tabs of the lock washer.



    C181091
  1. Remove the nut and the lock washer from the park/neutral position switch assembly.



    C080256E06
  1. Remove the bolt and the park/neutral position switch assembly.

    HINT:
    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.