Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR

SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION REVOLUTION SENSOR (SP2)
  1. Coat a new O-ring with ATF and install it to the transmission revolution sensor (SP2).

  1. Install the transmission revolution sensor (SP2) with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission revolution sensor connector.



2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
  1. Apply MP grease to the pin.

  1. Install the floor shift gear shifting rod sub-assembly to the transmission control shaft lever RH with the pin and a clip.

  1. While pushing the shift lock release button, move the shift lever to N.



    C257566
  1. Using tape, hold a 0.3 mm feeler gauge on the floor shift control select lever.



    C257565
  1. Using tape, attach the floor shift control select lever to the console box assembly.

    NOTICE:
    Make sure that the feeler gauge is not on the area shown in the illustration.



    C116831E01
  1. Turn the transmission control shaft lever RH of the park/neutral position switch assembly counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

  1. Temporarily install the floor shift gear shifting rod sub-assembly with the nut.

  1. Tighten the nut while lightly pushing the lever rearward.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Do not push the lever too hard.



3. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)


4. INSTALL TRANSMISSION REVOLUTION SENSOR (NT)
  1. Coat a new O-ring with ATF and install it to the transmission revolution sensor (NT).

  1. Install the transmission revolution sensor (NT) with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission revolution sensor connector.



5. INSTALL NO. 2 ENGINE UNDER COVER
  1. Install the 7 bolts and the No. 2 engine under cover.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



6. INSTALL NO. 1 ENGINE UNDER COVER


    A280546
  1. Install the No. 1 engine under cover with the 12 bolts and engage the 7 clips.
    V100135
    Bolt A
    V100136
    Bolt B

    Torque:
    Bolt A:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }
    Bolt B:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }