Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR

SPEED SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A278294
  1. Disengage the 7 clips and remove the 12 bolts and No. 1 engine under cover.



2. REMOVE NO. 2 ENGINE UNDER COVER


    A278295
  1. Remove the 7 bolts and the No. 2 engine under cover.



3. REMOVE TRANSMISSION REVOLUTION SENSOR (NT)


    C258471E01
  1. Disconnect the transmission revolution sensor connector.
    Text in Illustration 
    *1
    O-ring

  1. Remove the bolt and the transmission revolution sensor (NT).

  1. Remove the O-ring from the transmission revolution sensor (NT).



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


5. REMOVE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
  1. While pushing the shift lock release button, move the shift lever to N.



    C260576
  1. Remove the clip, pin and the floor shift gear shifting rod sub-assembly from the transmission control shaft lever RH.



    C260577
  1. Remove the nut and disconnect the floor shift gear shifting rod sub-assembly.



6. REMOVE TRANSMISSION REVOLUTION SENSOR (SP2)


    C258472E01
  1. Disconnect the transmission revolution sensor connector.
    Text in Illustration 
    *1
    O-ring

  1. Remove the bolt and the transmission revolution sensor (SP2).

  1. Remove the O-ring from the transmission revolution sensor (SP2).